SKYLITE FLASHING STUDIO

Shape your flashing brief.

Explore the size, roof covering and finish, then send your concept to Skylite for review.

Prefer help choosing?

Configure your design

All dimensions are in millimetres. Start with approximate measurements if needed.

Starting design Skylight arrangement Roof covering

Base dimensions

Width mmLength mm

Roof pitch 15°

The base is measured at the upstand. It does not establish the correct opening for a specific skylight model.

FinishCOLORBOND® finishColour

Monument · Classic

View the manufacturer's colour chart. Screen colours are approximate; confirm an actual sample and availability.

Separate back tray

Adjust flashing dimensions

These are concept dimensions for discussion. Skylite will review drainage, clearances, joints and manufacturer requirements.

Surround

Upstand mmTop return mmSide flange mmFront apron mmRear flange mmEdge upturn mm

Upturn location

Tile mode starts with a provisional 20 mm side/rear upturn and keeps the front apron open. The required detail must be confirmed for your roof.

Back tray dimensions

Tray length mmRear overlap mmSide upturn mm

Applies when a separate back tray is included. Tray width follows the base and side flanges.

Requested sheet thickness

YOUR CONCEPT

See it take shape.

800 × 1200 mm

Edit dimensions

3D PREVIEWDrag to rotate · arrow keys also work

Overall footprint1100 × 1700 mm

Roof coveringMetal

Back trayNot included

Send this design for review.

Your dimensions and finish will be included in your prepared email brief.

Concept planning only. This preview does not confirm model compatibility, structural suitability or waterproofing. Skylite must review the final details before manufacture. Three-unit sizes and spacing are illustrative. Workshop and cutting exports are not supplied by this customer tool.

Review all design details